Results 21 to 30 of 110
-
04-30-2014, 05:38 PM #21
- Join Date
- Apr 2014
- Posts
- 1
I really want to test one, but I'd need a 3 (2.8 to be more precise) mm version.
-
04-30-2014, 06:13 PM #22
My my this looks great.
This is not restricted to pellets right ? I mean you can also recycle prints, plastic bottles .. Correct ?
What kind of safety features do you include ? Auto cut off when Jammed or empty ?
What is the diameter precision range/repeatability ?
Regards
-
04-30-2014, 06:23 PM #23
- Join Date
- Apr 2014
- Posts
- 228
As far as I'm concerned, it's incomplete without a winder, it's leaving half the project undone. There's little point in running a filament extruder without a way to take up & store the output. Any manual handling of the output causes jiggles at the nozzle.
And please don't claim to be able to extrude PLA unless you actually show a good measure of PLA being extruded. Everyone shows footage of ABS being extruded, that's actually pretty easy. No one that I have seen has shown footage of their machine extruding PLA, and as such, I am dubious as to whether anyone can do it reliably with such a small machine as these hobby extruders.Last edited by JRDM; 05-01-2014 at 07:59 AM.
-
04-30-2014, 08:55 PM #24
- Join Date
- Apr 2014
- Location
- Timaru, New Zealand
- Posts
- 2
This looks great very smart design.
I'm only just getting started with 3D Printing. I think ill be snapping one of these up when they become available on Kickstarter especially at that price thats very reasonable
-
04-30-2014, 09:04 PM #25
- Join Date
- Oct 2013
- Posts
- 7
Very keen to see the Kickstarter when you launch it - this is just what I've been shopping around for this week (and NOT finding!).
-
04-30-2014, 09:50 PM #26
- Join Date
- Apr 2014
- Location
- New Zealand
- Posts
- 10
Looks promising, is your Kickstarter campaign going to be open to international backers? if so I hope you're investigating some good deals on international shipping.
Also as JRDM pointed out, a winder would be a great addition.
-
05-01-2014, 06:57 AM #27
-
05-01-2014, 10:35 AM #28
-
05-01-2014, 11:38 AM #29
- Join Date
- Jan 2014
- Location
- Sweden
- Posts
- 18
The spec stated that :
"Filament Tolerances: 1.75mm (+ .1/ – .1) & 3mm (+ .1/ – .1). with nozzle change."
Is that a typo? Your competition claims +/-0.04 to +/-0.05mm at most.
-
05-01-2014, 04:55 PM #30
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help