Results 1 to 10 of 20
Threaded View
-
08-24-2020, 03:13 AM #12
- Join Date
- Aug 2020
- Posts
- 1
abs separate in UV, or so they state.. you should take a gander at PETG for this part on the off chance that it is just warmth/sun that is driving no PLA. The part looks straightforward without a great deal of little projections. PETG would be great, I use it for outside camera mounts. No walled in area, not distorting yet not an edge as ABS but rather entirely tough curves a great deal before it breaks.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion