Results 1 to 10 of 14
Thread: Ape
Threaded View
-
05-01-2014, 01:14 PM #10
I'm thinking I might have sliced it wrong. And I used honeycomb support material. So... I need to retry it. I used ABS plastic. I guess PLA would be stronger so maybe I should switch that too? But I like ABS!
On the Pumpjack:
I'm poor. I can't afford the fancy equipment. I only have a single extruder. I didn't paint the Pumpjack. I switched the filament at strategic times during the print. I did this out of necessity: http://3dprintboard.com/showthread.p...ltipanel-Users
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help