Results 1 to 6 of 6
Threaded View
-
08-11-2020, 10:58 AM #3
My apologise for the delay in reply, I was away last week.
I THINK this photo is of the broken-off part. (Naturally, 2020 being 2020, I of course now can't find the other bit of it - and its not like we intentionall threw it away or anything. *sigh*)
SAM_3298.jpg
And the reverse side
SAM_3299.jpg
Edit: This point had become somewhat irrelvant. The Rep 2's x-axis belt has gone (making this the third bit to break or wear out in this period) and we have reached the point that we think it's time to replace it after 7 years and 2770 hours of printing time. (My Dad has risked a tenner on a replacement belt from a clone hopefully for the short term, while we sort out and get a new one in.)Last edited by Aotrs Commander; 08-12-2020 at 07:19 AM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion