Results 1 to 4 of 4
Thread: Top of print , quality
Threaded View
-
08-08-2020, 08:52 AM #4
- Join Date
- Jul 2020
- Posts
- 12
Hi DavaX,
If you use Cura you can switch on "Ironing" in the settings.
It makes the nozzle go over the top layer again with very little filament extruded.
On the negative side it adds to the print time.
Hope this helps,
Andy
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion