Results 1 to 2 of 2
-
07-30-2020, 10:11 AM #1
Issue with filament while printing
Having an issue and hoping for some help... I recently replaced the following on my Makerbot Replicator2: Heater block assembly, thermocouple, and the heater cartridge. I have made some really nice prints since the replacement but a couple of days ago i started to have a few issues. The filament would just stop. It didn't break and I would unload the filament and it looks like the attached image??Before I take the whole assembly apart I am looking for an answer - is it the temp that i am running (usually 220 to 230) or is the assembly itself? Thanks in advance for all answers.
-
07-31-2020, 09:56 AM #2
huh looks like you've stripped out the teflon tube lining.
Different - but I'd breaj it apart and check.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion