Results 11 to 12 of 12
Thread: This happened last night.
-
04-30-2014, 01:06 PM #11
- Join Date
- Apr 2014
- Posts
- 23
I've actually had this happen to be before too. Luckily I was only in the other room, and I caught it before it caused any major problems.
-
05-13-2014, 11:49 AM #12
- Join Date
- Mar 2014
- Posts
- 223
I just noticed that Slic3r writes the volume of filament used on the GCode, it's at the end of the print code, before the settings section. That makes calculating the weight of filament needed for a print much easier.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion