Results 1 to 6 of 6
Threaded View
-
07-20-2020, 02:12 PM #4
Knew it was a long shot.
Post your 3D Printer specs, along with which firmware you are using.
You may need to calibrate your steps per mm on your Z-Axis
Knew it was a long shot.
Post your 3D Printer specs, along with which firmware you are using.
You may need to calibrate your steps per mm on your Z-Axis
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion