Results 1 to 6 of 6
Threaded View
-
07-20-2020, 02:12 PM #4
Knew it was a long shot.
Post your 3D Printer specs, along with which firmware you are using.
You may need to calibrate your steps per mm on your Z-Axis
Knew it was a long shot.
Post your 3D Printer specs, along with which firmware you are using.
You may need to calibrate your steps per mm on your Z-Axis
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion