Results 1 to 10 of 10
Threaded View
-
04-30-2014, 04:48 AM #10
- Join Date
- Oct 2013
- Location
- Honolulu, HI
- Posts
- 199
I've spent some time trying to figure the z-ribbing out. There are some very good write-ups on printrbottalk about it. However, when folks finally started calculating the real values for the ribbing you can expect for having mis-matched screw pitch and step the values were in the single-digit micron range. This is sub-microscopic. The conclusion is that visible z-ribbing is a result of lead screw wobble, loose screws, etc. The lead screw measurements do not effect visible z-ribbing at all. Please feel free to head on over to their forum and do some reading on this.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)