Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 16

Threaded View

  1. 07-06-2020, 07:37 AM #2
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    1. I installed a switch so merely turn my 3D Printer off when finished 3D Printing.

    2. Cleaning your bed after print is correct, I also clean my bed with alcohol before 3D Printing to remove the debris, yes/no

    3. I store filament in a large plastic tub with one of these from the dollar store.

    Moisture Eliminator.jpg

    4. Filament, Heater - for Hot-end, Thermisters for bed and hot-end.
    Last edited by Roberts_Clif; 07-06-2020 at 09:40 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules