Quote Originally Posted by curious aardvark View Post
the fact that their own slicing software can't generate supports is pretty bad.

So what problems are you having ?
That;s always the best place to start :-)
And have you tried chitubox ? https://www.chitubox.com/
That way you can check if the issues you have are with the printer or the slicing.

I am having trouble getting the print to stick to the build plate consistently. Also, I have used meshmixer to orientate and generate auto supports (using the SLA/DLP printer support settings) for all the prints I have done. I have had almost zero successful prints using the orientation tool and supports. The initial layers either do not stick to the build or halfway through the print the part falls off the supports. All of my successful prints have been without supports but I have had plenty of non-support prints fall off too. I have tried adjusting layer cure times, initial amount of layers and adding resin to the build plate before printing to make sure there are no air bubbles.