Results 1 to 5 of 5
Thread: Help on overhangs
Threaded View
-
06-26-2020, 11:45 AM #5
- Join Date
- Jun 2020
- Posts
- 3
oh i did put supports beneath them but i think i didnt do the settings correctly.
i drew the model myself for now the length of it is like 10cm/4 inch?that is possible but im just looking for a way to do this as i also have problems printing fillets from the bottom up. feels like there should be some setting where i could do to make it support better and able to print nicely except that i don't know where it is.
edit: i drew the thing in like 20mm...so i scale it up to sliceLast edited by oneredlime; 06-26-2020 at 01:37 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help