Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 15

Threaded View

  1. 06-21-2020, 08:57 AM #2
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    My 3D Printer enclosure has a light dimmer control and a bathroom fan. I have a vent hole that the fan draws air from.

    When printing any model with air flow can ruin prints, I use only enough air flow to keep smell moving to outside vent.
    I have printed ABS with this constant air flow low enough that the print came out near perfect.
    Last edited by Roberts_Clif; 06-24-2020 at 07:31 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules