Results 1 to 10 of 11
Threaded View
-
05-18-2020, 09:16 PM #6
- Join Date
- May 2020
- Posts
- 6
I am using Cura.
I just tried flipping the funnel vertically so that it prints upside down (mouth side down) and also adjusted the layer height to 0.16mm and wall thickness to 1mm and that resulted in a significantly better print, though still far from perfect.
I will adjust a few more settings and try again.
Thanks for the advice.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help