Results 1 to 3 of 3
-
05-02-2020, 08:20 PM #1
- Join Date
- May 2020
- Posts
- 1
Ender 3 Pro PETG 1.75 - Complete mess
I am 100% a noob. I just purchased a Ender 3 Pro. I ordered PETG on accident. My PLA prints nice. PETG not so nice. I have read lots of articles and watched lots of videos. None of them seem to work for me. Can you take a look at the attached files and tell me if I am running to hot/cold , to fast/slow or to thick. I have attached my settings on the screen. I tried 230c all the way up to 248c on the temperature. Any help would be greatly appreciated.
-
05-03-2020, 03:26 AM #2
- Join Date
- May 2020
- Posts
- 6
Hi monkerz,
Seems to me that your extruder is a little bit too close to the bed.
The best way to determinate what temperature is the most suitable for each material in your printer is doing a temperature test.
You can find files for print tower temperature tests over the Internet in repositories like Thingiverse.
A tower test print makes different prints going from X to Y temperature, increasing for example +10ºC in each stage, so then you compare them to determinate which prints the best for you.
Let me know if you have any trouble with it.
Best regards.
-
05-03-2020, 08:29 AM #3
hmm, bed temp should be 85c
printspeed 40mm/s MAXIMUM
try 30mm/s to start with.
First layer speed S-L-O-W Say 10%
Also what surafce are you printing on ?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion