Results 1 to 8 of 8
Threaded View
-
04-27-2020, 03:10 PM #6
- Join Date
- May 2018
- Posts
- 566
So I printed the same box (3 layers on bottom .5mm layer) and vase mode sides .8mm thick, in PLA. I left the door of the enclosure open and the front of the box lifted a bit but is still usable. Did not happen with the lid as I closed the door for that job. The PLA (not clear, eSun pla+) is a bit stiffer than the petg as expected which is better for a box.. just have to make sure it is never put it too near anything too hot.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion