Results 1 to 10 of 13
Threaded View
-
04-27-2020, 02:35 PM #7
basically the lid is too,large - if you load both into simplify3d you can clearly see the lis is larger than the box.
So a simple fix is just resize the lid.
that can be done in a slicer, or in the cad program.
Also the lip at the end is higher and larger diameter than the piping along the sides . Given that all the indents are the same size and aligned.
That is also an issue :-)
It would be a 1 minute fix in openscad - not a clue in fusion 360.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion