Results 1 to 10 of 13
Threaded View
-
04-26-2020, 07:59 PM #8
If the Body above the Half round was reduced or angled a little this might allow it the snap into place.
Or
If they did not come so close to the corners.
This is the reason I used the fingers with round ends to give it flexibility.
Though it was not one of my best ideals, it been working for 2 years now.Last edited by Roberts_Clif; 04-26-2020 at 08:06 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion