Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 13

Threaded View

  1. 04-26-2020, 07:28 PM #6
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    Hello I'am Back.

    I have a question about your enclosure .

    Lid
    Lid.jpg
    Body
    Body.jpg

    I noted that you have a Half round indention in your body and a half round pin on your Lid.

    How is this suppose to snap together, to me it looks like it is too tight.
    With two sides each having a 1.571mm half round will the 3.142mm snap into place at the corners.
    Last edited by Roberts_Clif; 04-26-2020 at 07:55 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules