Complete mess after a few layers, beginner needs help :)

[curious aardvark]

looks like the bed is not level. The side with the mess is either nearer or further away from the print nozzle than the other side.
OR you have an automatic bed levelling sensor and it's over compensated on the one side.
OR the bed is not stable.
Also which side is the mess on ?
ie: near the extruder (left as you look at the control panel) or the right ?

It's an ender 3 - so could be almost anything.
So I've started with all the ways I can think of that the bed might not be level.

(has a look at the 3x) OH MY GOD, just when you think they've madethe design as bad as they can, they go and take a chunk out of the base frame and make it even worse !
You now have t worry about how level the surface the bloody thing is sitting on is. Sheesh.
I'm going to take a wild guess that the bad side is on the right ? (my first guess was left).
Someone at creality REALLY hates Gwailo !