Results 1 to 10 of 10
Threaded View
-
04-09-2020, 03:32 PM #5
- Join Date
- Apr 2020
- Posts
- 8
It could totally be a problem with the firmware, I compiled it myself. Its a hypercube evolution that was a complete DIY build. The failure occurs about 40% of the time on prints longer than 5 hours. For shorter prints, they finish just fine. So assumed it wouldn't be a firmware issue. But I'm really not sure what in the firmware could cause that.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help