Results 1 to 7 of 7
Threaded View
-
03-25-2020, 11:57 AM #1
- Join Date
- Mar 2020
- Posts
- 3
Bad - Monoprice MP Select Mini V2 3D Printer
Hi all,
Ive got this printer from the university to finish my robotics project at home (due to the virus).
I have tried to print out but it seems that at most cases the printer is not extruding properly. I have attached some photos of a few samples.
I have tried hard to look at some example videos and manual instructions in order to fix this issue.
I did tried to:
Adjust the bed level and check with piece of paper, multiple times;
Clean the nozzle and the filament pathway;
Adjust the settings of the printer including: layer height, print speed, travel speed, infill density, retraction distance, retraction speed and the temperature of the nozzle/bed.
Any ideas what else can be causing this issue?
Its almost like the filament is sliding on the bed.
In addition: the middle of the bed is slightly higher than all 4 corners. Perhaps what is the issue? If that`s the case, is there a way to solve it?
Many thanks!
Arnold
Printer Link:
https://www.monoprice.com/product?p_id=21711
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help