Results 1 to 4 of 4
Threaded View
-
03-25-2020, 12:33 AM #1
- Join Date
- Mar 2020
- Posts
- 2
Repeatable small gap in between layer
Hi all,
My printer is an anycubic i3 mega and I am using Hatchbox orange PLA.
When using a 0.2mm layer height with this model, I only saw one small gap per print sometimes but to try and accelerate the process. I tried a 0.3mm layer height. You can see the result with the photos.
IMG_20200325_002216.jpgIMG_20200325_002229.jpgIMG_20200325_002244.jpg
The inside of the box is full gap between the layer only on the exterior layer and on the outside of the box it's all clean, nothing.
I tried slowing the speed from 60mm/s to 35mm/s and also tried a higher temparature, from 200 degre C to 225. In comparison, I use 50mm/s with 0.2mm layer height
Those modification did improve the quality but not enough.
In the title, I say repeatable because no matter the speed, temparature and even the orientation on the bed. The gap always seems to be on the same layer.
I suspected a problem with the model but I have no issue printing with a 0.2mm layer height. I tried to print a calibration cube to see if the same error occurs.
The result of the calibration cube is that yes it did it again but only one time and a really small one but I still think it counts.
What do you think is my problem, I would like to know what you think.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help