Results 1 to 4 of 4
Thread: QiDi 1 layer shift issues
Threaded View
-
02-25-2020, 03:45 PM #3
- Join Date
- Feb 2020
- Location
- Orlando, FL
- Posts
- 2
Thanks for the response!
I have leveled the bed, and as near as I can tell the surface is stable (I've tried printing on a couple different tables)
I hadn't considered that it might be moving *too* slow, I may go back and try with some different settings. And I am printing with PLA and the fans are enabled.
Do you know how to reset to factory on this device? That is something I have been wanting to try but haven't found a guide on it just yet and I'm nervous about bricking the machine lol.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help