Results 1 to 3 of 3
Thread: polysmoth transparent bad print
Threaded View
-
02-24-2020, 06:30 AM #2
well first off - why are you using retraction in vase mode ?
Shouldn't be necessary.
There is no actual movement between layers that requires retraction.
Also 4.5 mm is a LOT.
what printer do you have ?
Also lookin at the print, the actual thicknes of the model is more than a single layer - so VASE mode is not appropiate.
Vase mode should be used for single line walled shapes and is - usually - a continuous line that doesn't use retraction because it never stops actually extruding.
That model wall looks yoo thick for vase mode - to me.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help