Results 1 to 3 of 3
-
02-09-2020, 12:28 PM #1
- Join Date
- Jul 2019
- Posts
- 5
I can't remove my printins from the new crystal bed
I've bought a new crystal bed for my Ender 3 because the one that comes with the printer was kind of worn out and not very beautiful. But after my first printing I find it impossible to remove the piece, it's stuck as hell. I've tried everything I've seen on the Internet:- Putting the crystal bed with the piece in the freezer for 15 minutes - Reheating the bed with the plate on- Using a 50% alcohol and 50% water solution to try and remove it- Of course, fist of all, using the scratcherAll of them with no results. Any ideas, please?
-
02-09-2020, 07:03 PM #2
- Join Date
- May 2018
- Posts
- 566
I use a cake icing spatula. for items that are more than 10mm tall I smack them with the wooden handle of the spatula. For smaller items I smack them with the blade of the spatula so to goes under the first layer.
Mine looks just like this
https://www.amazon.com/Ateco-1375-St...%2C393&sr=8-52
-
02-14-2020, 10:26 AM #3
hammer.
often a sharp tap will knock somethiong loose.
what's a crystal bed made of ?
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion