Results 1 to 5 of 5
Thread: Ender 3 Mobo repacement....
-
02-04-2020, 06:45 PM #1
- Join Date
- Feb 2020
- Posts
- 18
Ender 3 Mobo repacement....
Si I broke the USB connector on my Ender 3 and it was intermittently not running the extruder motor during prints so I decided to buy a cheap mobo to replace the factory one. I will detail what I have done in this thread.
Here is the mobo I bought: https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1
I have already installed the mobo and I am getting ready to modify the firmware for my bltouch. Here are some pics while you wait for more:
Yes they included the rubber ducky:
Next to the factory mobo:
Installed:
-
02-04-2020, 10:40 PM #2
- Join Date
- Feb 2020
- Posts
- 18
Firmware has been a pain in the butt to get working but WOW is it super quiet now. You can barely hear the motors. I am going to bed. I will report back more later.
-
02-05-2020, 07:13 PM #3
- Join Date
- Feb 2020
- Posts
- 18
I had some issues getting my bltouch to work while compiling the new firmware. It is working now. I am currently working on getting it calibrated with simplify3d and printing a good first layer. It is nearly silent while printing. I am really impressed with how quiet it is.
-
02-05-2020, 07:14 PM #4
- Join Date
- Feb 2020
- Posts
- 18
OH and that installed pic is incorrect. There is an actual plug on the board for the bltouch so I didn't need that adapter and I had to switch the grd and 5v wires on the bltouch lead.
-
02-06-2020, 01:03 PM #5
- Join Date
- Feb 2020
- Posts
- 18
More info. If you switch to this mobo when you compile the firmware the instructions have you bring of the configuration.h and configuration_adv.h from the Marlin-2.0.x\config\examples\BigTreeTech\SKR Mini E3 1.2 folder and put them in the Marlin-2.0.x\Marlin folder and then edit them in the Visual Studio Code editor.
Well if you are using a bltouch you need to uncomment #define Z_SAFE_HOMING. You also need to comment out #define MESH_BED_LEVELING and uncomment #define AUTO_BED_LEVELING_BILINEAR. That will get the bed leveling working. #define GRID_MAX_POINTS_X and #define GRID_MAX_POINTS_Y are set to 5 which makes it probe 25 times which may be excessive and more time consuming but I am going to leave it at that for now. With my old motherboard it was set to 3x3. I may go to 4x4 if the extra time annoys me.
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help