Results 1 to 7 of 7
Thread: Persistent Warping with PETG
Threaded View
-
01-28-2020, 08:13 PM #6
- Join Date
- Jan 2020
- Posts
- 6
Thanks, I've been using the paper method. I looked for a Z offset on the stock firmware of the Maker Select v2 but not seeing it. I noticed my bed might be warped because I can't get all four corners leveled. Two of the opposing corners will be too low, and the other two are too high, which is impossible to fix. I got it as close as I can, and I also bought mirror tiles from Home Depot and used the hairspray method to stick to it better. I re-designed my part with 1mm discs around the corners and I am going to put a radius on the corners next time. It doesn't appear to be warping very much, but sometimes it doesn't happen until the end, and I still have about 40% to go, so I will check back afterwards. I can't find the setting for extrusion width in Slic3r. I will try 70C for the bed. I've been setting it to 100 and extruding at 250.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion