Results 1 to 1 of 1
-
01-18-2020, 04:25 PM #1
- Join Date
- Jan 2020
- Posts
- 1
Filament jamming - Anycubic I3 Mega
So I've been pulling my hair out over this as I can't seem to figure out what the actual problem is here.
I own an Anycubic I3 mega (had it for almost 1 year), and my fillament recently has been getting stuck in the teflon tube. It's not a nozzle clog as the fillament actually stops about 7/8 of the way to the actual print head. If I pull everything apart and replace the tube it's fine for a print or 2 then it just gets stuck again about halfway through a print. Has anyone else had this problem beforehand?
We have recently brought different filament (cheaper) and it has played up so not sure if that could be an issue either
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help