Results 1 to 1 of 1
-
01-12-2020, 05:57 PM #1
- Join Date
- Dec 2019
- Posts
- 1
Just need info about this Hotbed Connector type
Hello everyone. I have a Tronxy XY-2 unit and two days ago i noticed my bed wasn't keeping the temp in fact it was going lower, well turned out that the red wire was burnt off from the housing.Here is a pic
https://ibb.co/4FLV946
My question is what size is this connector and more importantly what size/type of connector pin should I be looking for? I emailed Tronxy support already but so far no response. Thank youLast edited by hynostroza; 01-12-2020 at 06:11 PM.
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion