Results 1 to 2 of 2
Threaded View
-
01-07-2020, 09:22 PM #1
- Join Date
- Jan 2020
- Posts
- 2
parts are printing at angle, help!!!!
parts are printing at an angle in the Y axis i have checked the belts and the motor does not seem to be loosing steps, i have calibrated it over and over and its dead on every time, it always comes back to the same spot. I used two different slicers checked the gcode for anything out the ordinary and nothing. its consistent though, the y moves back just a hair each layer in the y axis but does not show any signs of doing so in calibrating. any help with this problem will be rewarded with life long happiness and a greater understanding of the universe, thanks.
Last edited by htes; 01-07-2020 at 09:31 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help