Results 1 to 1 of 1
-
01-07-2020, 09:05 PM #1
- Join Date
- Jan 2020
- Posts
- 2
parts are printing at angle, help!!!!
Printer is printing at an angle in the Y axis. it consistently shifts in the y axis building at an angle overlapping each layer. the belt is tight and the y calibration does not show any deviation when measured over and over again. i've used two different slicers, checked the gcode for anything out of the ordinary but nothing diferent, i'm stumped. anyone that can help fix this problem will be rewarded with joy and happiness in their life.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help