Results 1 to 5 of 5
Thread: heated bed issue
Threaded View
-
12-20-2019, 06:31 PM #2
- Join Date
- May 2018
- Posts
- 566
Most slicers have a Z offset where you can alter the starting Z point within the software so you set it to .1 and then do a -.2 in the slicer to offset the distance for the change when hot.
https://youtu.be/yPy0zDpmc5U
https://youtu.be/2sW25xt5E6U
Hope that helps!Last edited by airscapes; 12-20-2019 at 06:37 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion