Results 1 to 7 of 7
Hybrid View
-
11-18-2019, 11:58 AM #1
- Join Date
- May 2018
- Posts
- 566
The diameter of the filament is part of the calculation of how much is extruded so 1.68 i a lot less plastic than 1.75. Also if too thin the drive can slip .. you must measure multiple places over a few meter to get the average thickness and enter that into the appropriate location of the slier you are using..
Good luck
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help