Results 1 to 4 of 4
-
10-21-2013, 10:14 AM #1
OctoPrint (Control your Printer over Internet)
Hey guys,
Just a small discussion topic about Octoprint,
If you have any questions/problems you can put those here ^^
I got a Octoprint website myself running sometime if i realy wanna :P
I got it running on my PC since i don't own a raspberry yet,
Atm my printer is in my bedroom next to my pc, but that may change since well 3d printers arent realy that healthy to be in a area you are that much in ,
or it realy has to be well ventilated (wich i try as much as possible)
So i might change it from room, if i do well i might buy a Raspberry, or i just use my old laptop ^^
Oh well...
I've also got my Ipod as Webcam, For example you wanna see if the Makerfarm works well, I could give you a small Live show i guess ^^
Anyhow i thought this was a nice piece of software to create a Topic about ^^
Best regards,
DrLuigiLast edited by DrLuigi; 10-21-2013 at 10:16 AM.
-
10-25-2013, 05:25 PM #2
My son has been using Octoprint and Rasberry Pi to run our two Prusa i3 Printers. It is nice not having to tether the printers to a laptop all the time.
-
10-26-2013, 10:08 AM #3
Well if it wasnt next to my PC i would also put a raspberry on it,
But atm its still in my room next to my PC so ye i am running it for the Lolz sometime but don't realy need it,
I am planning to perhaps change it from place, To another room and then i might actualy buy a raspberry for it.
Can you use 2 printers on 1 octoprint? i believe not?
So you had to get 2 raspberrys and get 2 diffrent octoprints running? i am guessing that atleast.
-
10-29-2013, 11:46 AM #4
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help