Results 1 to 1 of 1
Thread: Getting it to stick !!
-
11-05-2019, 03:01 PM #1
- Join Date
- Nov 2018
- Posts
- 2
Getting it to stick !!
Someone - don't know who - on some website said
'set the first layer maximum speed to 5 mm/sec'
Since I've done this my prints stick to a glass bed like the proverbial to a blanket with no preparation apart from a good clean.
All the edge curling (I print with ABS) has gone and I've stopped messing about with extruder and bed temperature.
He deserves a medal.
Also I used to have a problem with the PTFE tube blocking with filament but that seems to have gone by reducing the retraction to 1 mm.
Hope this helps.Last edited by muddledsteve; 11-05-2019 at 03:52 PM.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help