Results 1 to 10 of 68
Threaded View
-
04-22-2014, 12:03 PM #10
Just as an update, It kinda resolved now,
After a few clicks i gave it every few hours, it kinda became better and better.
I did have a few crashes tho, that it pressed once, went up, went back down and didnt stop immeaditly lol.. Hopefuly that doesnt happen anymore :P
/edit
Just had it again, weird it just goes to the platform, totaly pressed and just doesnt stop lol..
/edit
Well i guess i have found the problem, and a solution, I guess my glass was just to dirty of hairspray that it seem to have probems with it,
I cleaned it and it does it again just fine.Last edited by DrLuigi; 04-22-2014 at 01:35 PM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion