My prints recently have been terrible but on only one side of the printed object, the right side. I assume this could be a leveling problem and I am going to run some tests however I would love some opinons on what it could be since I have never had this problem before.

I did recently switch to a different brand of PLA (Overture - cheap on Amazon) but the previous one was also some cheap brand from Amazon. Both are white, PLA, printing with the same temperature (220º C), details laid out below.

Any thoughts would be appreciated.

Printer Model: MONOPRICE SELECT V2
PLA Brand: OVERTURE (cheap from Amazon)
Printing Temp: 220ºC

If you want more info I can provide no problem.

2019-10-24 13.02.24 copy.jpg2019-10-24 13.01.46 copy.jpg