Results 1 to 8 of 8
Threaded View
-
10-31-2019, 04:32 AM #2
- Join Date
- Jun 2014
- Posts
- 885
I would use a soldering iron and carefully push away the material from the nozzle. If one uses great care and has a hot air gun with a reduction nozzle, one could also heat up the PLA and push it off with a utensil. PLA will heat quickly throughout the mass, so expect that a large portion will droop, drip or otherwise move once the necessary temperature is reached.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion