Results 1 to 10 of 24
Thread: Ender 3 and leveling problem
Threaded View
-
10-25-2019, 07:24 PM #2
Give us an example of how large the gap difference is.
Myself I spit the difference as to make an average bottom layer thickness that I can live with.
And print dual top/bottom and wall thicknesses.
I have also tweaked my 3mm Aluminum Bed.
This made the bed flatter allowing my smaller offset to be within a decent working area.
I had been 3D Printing over 2 years with PLA and only noticed the bed warping after Printing ABS.
I Mapped the bed Height, removed it from my 3D Printer and Adjusted it to a livable level.Last edited by Roberts_Clif; 10-25-2019 at 07:36 PM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion