Results 1 to 10 of 39
Threaded View
-
10-10-2019, 07:48 AM #26
- Join Date
- May 2018
- Posts
- 566
From what i recall the OP never printed any calibration models to set starting Z offset properly which could be the only thing wrong as it needs to be changed per layer height and it can be functional differences between 70C bed and a 110C bed. Adding the thick layer of PIE to a bed that is not close enough to start would help and would help more than adding a paint on liquid.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help