Results 1 to 10 of 107
Threaded View
-
04-21-2014, 09:45 PM #11
Yep, I actually would prefer the extruders to be closer together (wha?) yeah, when they are set up right and don't drag, ideally they could be even closer together. This would allow a bigger build area, and levelling the build plate would also be easier.
The problem I have that is a constant on my machine is the slightly sagging heatbed (should have a new one soon) when you level the heatbed, you will find the extruder closest to the edge is always a tighter tolerance to the one closer to the center of the plate. I have adjusted the height of my nozzles to compensate for this, but ideally I wouldn't have liked to do that. If they were set at even 20mm apart, this would facilitate in getting the hot bed even more level because both nozzles are closer to the edge giving you a more precise area to level rather than that rough inch you need to account for due to one nozzle not being on the edge of the platform.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion