Results 1 to 10 of 16
Thread: ABS Cracks and Gaps
Threaded View
-
09-24-2019, 06:35 PM #8
- Join Date
- Sep 2019
- Location
- California, O'side
- Posts
- 9
Yeah, I hear ya. I do the same, mostly always printing using PLA and ABS. I've also printed with Proto-Pasta Stainless Steel. I liked it! Just too expensive...I've also tried ColorFab Bronze, again very expensive, and I still have figured out how to use it...I print using a Flashforge Creator Pro and a Xinkebot Orca 2 Cygnus. What do you have? Have you tried any exotic filaments? Do you go as far as using Acetone on your finished prints to remove the lines and create a smoother prototype? Just curious how you like doing that? If you do, is it alot of work working with Acetone?
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help