Results 1 to 9 of 9
Threaded View
-
09-22-2019, 01:59 PM #3
- Join Date
- Jan 2019
- Posts
- 24
So I figure out it was the X axis bar when assembled stright was actually curving down a few mm (where I was getting the nozzle being closer on one side than the other even when all 4 corners where tightened down all the way). So I loosened the 2 screws that bolt the bar to the axis trigger piece that slides down the z axis frame and pushed it up as far as it would let me before re-tightening the bolts which only put it about a half mm off, but I can fix with bed level adjustment. I do like the stiffer springs though, takes more effort to adjust the level and feels like it wont unadjust itself as easily as the original springs. I plan to get a Prusa eventually, but I wanted something to prototype with while my main printer was doing the quality prints
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help