Results 1 to 4 of 4
Threaded View
-
09-20-2019, 02:13 AM #3
- Join Date
- Sep 2019
- Posts
- 2
Hello Nikolay!Thank you for making this open source!I have replaced the main board of my Anet A8 printer.After many issues I have finally got to a point where all the motors work as well as heating and sensors.However I am unable to print due to the motors seem to run too much. When I execute `x5` it moves more than 5 cm. How can I figure out what values should go to the config of PyCNC? I use Cura, maybe a different slicer/gcode format needs to be chosen? Thanks!!
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help