Results 1 to 10 of 17
-
08-11-2019, 09:26 PM #1
- Join Date
- Aug 2019
- Posts
- 9
Creality Ender 3 extruder nozzle zeros itself off and below bed
So we don't know what happened, things were working fine and now every time we go to press the Auto-Home feature, the extruder nozzle now zeros itself off and below the bed.
We've tried playing around with some settings, but were at a wall as to what to do to fix this.
I've attached a pic of what the extruder does when we Auto-Home.
Thanks.
-
08-16-2019, 12:38 PM #2
- Join Date
- Aug 2019
- Posts
- 9
Anyone have any ideas?
-
08-16-2019, 07:57 PM #3
I would start by resetting the Ender 3 to factory settings.
M502 ;Restore Firmware Defaults settings.
M500 ;Save settings to EEProm
Then I would Check all end-stop switches with a M119 ;End-stop States normal state an when switch is activated.
-
09-09-2019, 03:13 PM #4
- Join Date
- Aug 2019
- Posts
- 9
We went through the menu and we're not seeing any where to reset to factory settings?
Thank you.
-
09-09-2019, 03:53 PM #5
From the Menu it should say something like Restore fail-safe. Then Store settings.
-
09-12-2019, 07:08 PM #6
- Join Date
- Aug 2019
- Posts
- 9
-
09-12-2019, 07:58 PM #7
It should be under the Control menu,
-
09-12-2019, 08:53 PM #8
- Join Date
- Aug 2019
- Posts
- 9
Ok thanks, I think I found it now. I just need to have my dad come over and help me level the bed properly again.
I'll let you know if we have any more issues.
Thank you!
-
09-13-2019, 04:41 AM #9
If you have more questions post we will do our best to help you answer them.
-
09-18-2019, 07:42 PM #10
- Join Date
- Aug 2019
- Posts
- 9
So when we try to click on Store Settings inside of Control, the printer just beeps really loud and doesn’t open any more menus or options.
Any idea now?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion