Results 1 to 10 of 354
Thread: 370mm X 250mm X 300mm
Threaded View
-
09-10-2019, 05:54 PM #11
While this printer is down I am printing out all the parts I need with my failed 3 Color Mixing Printer, Printalicious. And these y end caps/ motor mounts are printed in petg and as the picture shows I have already revised this part from my original design..And before I even got the new part with more material installed I realized I need to make some sort of stop for the linear guides so they do not travel off the end of the rails. Back to the drawing board.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion