Results 1 to 10 of 354
Thread: 370mm X 250mm X 300mm
Threaded View
-
09-10-2019, 05:54 PM #11
While this printer is down I am printing out all the parts I need with my failed 3 Color Mixing Printer, Printalicious. And these y end caps/ motor mounts are printed in petg and as the picture shows I have already revised this part from my original design..And before I even got the new part with more material installed I realized I need to make some sort of stop for the linear guides so they do not travel off the end of the rails. Back to the drawing board.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion