Results 111 to 120 of 354
Thread: 370mm X 250mm X 300mm
-
09-06-2019, 05:14 PM #111
-
09-08-2019, 10:13 AM #112
-
09-08-2019, 10:54 AM #113
When I am done there will be 10 stepper motors driving this printer. And each motor will have it's own stepper driver so I will have 7 tmc2208 drivers and there are 3 drivers built into the MMU2S control board.
-
09-09-2019, 05:09 AM #114
so why have you gone for the central bed support over the side supports ?
I mean it is a pretty substantial central support. But surely the side supports make a more stable bed ?
-
09-09-2019, 05:51 PM #115
-
09-09-2019, 07:15 PM #116
Last edited by AutoWiz; 09-09-2019 at 07:24 PM.
-
09-10-2019, 05:54 PM #117
While this printer is down I am printing out all the parts I need with my failed 3 Color Mixing Printer, Printalicious. And these y end caps/ motor mounts are printed in petg and as the picture shows I have already revised this part from my original design..And before I even got the new part with more material installed I realized I need to make some sort of stop for the linear guides so they do not travel off the end of the rails. Back to the drawing board.
-
09-12-2019, 06:23 AM #118
-
09-13-2019, 04:47 PM #119
-
09-13-2019, 04:49 PM #120
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help